Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones descargar pdf (Pagina 6)

Locate blower motor on the firewall (Passenger

Side) in engine compartment. Remove 5 nuts around

blower. Also disconnect electrical connector from

the blower motor.

Cut wires at grommet in firewall.

DRAIN COOLANT FROM RADIATOR.

Cut Heater hoses approximately 1” from firewall.

Remove the screw that is located just in front of the

air inlet to the heater.

Retain original hardware.

Picture to the right shows the heat

distribution duct attached to bottom of the

heater. This picture shows heater assembly

outside of the vehicle. The heat duct must be

removed while in the vehicle.

Remove push pins.

Locate on the right side of

lower dash. (2) bolts. (1)

inside glove box opening and

into the kick panel. (1) under

glove box opening and into a

bracket.

Remove and retain hardware.

PUSH PIN

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Sin comentarios

Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones Pagina 6