Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones descargar pdf (Pagina 11)

Locate in the hardware sack kit the evaporator

Support Bracket.

Attach bottom end of the bracket to the (2) 1/8” Dia.

holes in front of the evaporator using (2) #10 x 5/8

pan head Philips screws.as shown.

Holding the unit level attach top end to the cowling

using (1) #10 x ¾: hex head tek screw.

Tighten all screws.

Locate the Firewall Block Off Plate.

On engine side of firewall attach over the hookup

tubes from evaporator using (2) #10 x 5/8 “ hex

washer head Tek screws.

Locate insulation tape provided and seal around the

hookup tubes as shown.

Locate the Water Valve and (3) worm gear clamps.

Supply line from the engine is attached to the lower heater hookup tube. Cut 6” off the end of

return line and install the water valve using (3) worn gear clamps as shown above.

See Techinal Data sheet on page 24.

Note: It is recommended that you replace heater hoses from the engine to the hookup tubes.

Locate the ½” Dia. x 6” long piece of clear

drain tube.

Insert through 11/16” Dia. hole previously

drilled and attach over drain nipple on the

evaporator. Using the insulation tape seal

around tube.

Water Valve / (3) hose clamps.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 26 27

Sin comentarios

Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones Pagina 11