Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones descargar pdf (Pagina 5)

Removal of the control head requires

disconnection of the Mode Control cable.

This is located below the defrost duct.

The Temperature Control cable is located on top of

the heater, behind glove box opening.

Located behind glove box opening and on front of the

heater is a resistor assembly. Disconnect wires and cut

off the single wire to the blower motor.

Remove the Defrost Air

Duct along the body

flange.

Remove the (3) nuts.

Retain original hardware.

Set aside for modification.

(3) STUDS HOLDING DEFROST

CUT HERE

1 2 3 4 5 6 7 8 9 10 ... 26 27

Sin comentarios

Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones Pagina 5