Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones descargar pdf (Pagina 10)

Locate the Inlet Block off Plate.

Located above glove box opening place

block off plate over the hole. Attach with

(2) #10 x ¾ “ hex washer head tek

screws.

Locate Evaporator. Slide evaporator up into place behind the glove box opening.

From engine compartment attach evaporator using ¼ - 20 x

5/8 hex head screw with ¼” washer through the 5/16” Dia.

hole previously drilled.

Behind glove box opening attach the

blower support bracket as shown.

Attach with the original screw as shown.

Behind original screw you will find an

additional hole in the support bracket.

Install a #10 x ¾” hex washer head tek

screw through this hole and into the

cowling.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Sin comentarios

Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones Pagina 10