Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones descargar pdf (Pagina 21)

Locate the #8 discharge tube, and (1)

#8 o-ring.

Route tube through the hole and attach

to condenser using the o-ring and a few

drops of mineral oil.

Insert top bracket between shroud and the radiator bulkhead.

Attach bracket to the condenser in the top hole as shown.

Attach the bracket to the condenser using the #10 screws.

Slide condenser assembly to the left and up and down so that

the tube comes through the hole in the center.

Tighten shroud to clamp brackets to radiator bulkhead.

Locate the #6 liquid tube and (1) #6 o-ring.

Loosely attach tube to drier. Using the

other end locate and drill (1) hole 11/16”

diameter.

Insert the bulkhead fitting through the hole and

attach using the nut provided.

Tighten fitting and bulkhead securely.

Locate Hi-Low pressure switch ,electrical boot and

attach to top of the receiver drier using a few drops

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Sin comentarios

Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones Pagina 21