Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones descargar pdf (Pagina 16)

Route the heater hoses that were attached to the

bulkheads, and attach to the heater fittings on the front

of the unit.

Attach using (2) worm gear clamps provided.

Locate the firewall blockoff, (1) ¼”-20 x 5/8 hex head screw, (3) ¼”-20 flange nuts, and (3)

#10 x ¾ “ tek screws.

Insert the Blue clutch wire and the Temp control cable through the ½” plastic grommet in the

firewall blockoff.

Slide the blockoff over the suction tube, heater bulkheads, and insert the liquid tube through the

hole in the bulkhead.

The blockoff will slide over the studs at the bottom of the mounting bracket.

Attach blockoff using the flange nuts at bottom, (3) #10 tek screws across the top, and (1) ¼”

bolt and nut from the inside of firewall on the bottom left. Seal around a/c hoses using the

insulation tape supplied.

Locate in the hardware sack kit (1) single face outlet and (2)

#10 x ¾” tek screws.

STUDS

#10 SCREWS#10 SCREW

¼” – 20 X 5/8

SCREW & NUT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 30 31

Sin comentarios

Classic AutoAir Perfect Fit-Elite Series Instrucciones de operaciones Pagina 16